This seal is installed between the front motor seal and the front plate seal.

This is the front motor seal that gets pressed into the front motor housing frame of Balder motors. It is also used in the front nose case on most Norwalk juicers with either Baldor or Marathon motor installations. It is pressed in from the backside, so it isn't visually apparent from the outside. Check out the other motor shaft seals we have available such the intermediate seals found on Norwalk juicers.

This seal is pressed into the back side of the front plate where the motor shaft goes throught the front cover.

This intermediate shaft seal is located on the front motor shaft between the motor front end frame and the juicer front cover. Primarily found on Baldor motor installations.