.

This seal is installed between the front motor seal and the front plate seal.

.

This is the front motor seal that gets pressed into the front motor housing frame of Balder motors. It is also used in the front nose case on most Norwalk juicers with either Baldor or Marathon motor installations. It is pressed in from the backside, so it isn't visually apparent from the outside. Check out the other motor shaft seals we have available such the intermediate seals found on Norwalk juicers.

This seal is pressed into the back side of the front plate where the motor shaft goes throught the front cover.

This intermediate shaft seal is located on the front motor shaft between the motor front end frame and the juicer front cover. Primarily found on Baldor motor installations.

This replacement ball bearing is specifically sized for the Norwalk model juicer with Balder motors. Each motor has two bearings, one up front and one in the rear of the motor. These are sold as a pair.
*Note - Refer to the motor data plate, found on the side of the motor, to determine motor model.*

This replacement ball bearing is specifically sized for the Norwalk juicers with Marathon electric motors. Each motor has two bearings, one up front and one in the rear of the motor. These are sold as a pair.
*Note - Refer to the motor data plate, found on the side of the motor, to determine motor model.*

Specially design for the unique Norwalk juicer application, these electric motors have a double shaft design. The shaft located on the front of the motor, is used for the cutter and the shaft out the back is used for mounting the pump drive pulley.